working voltage 12V
current ≤8mA
working temperature +80℃ to -30
Max output current for one window ≤12A
Color black
Certification ISO9000 and CE
Brand Name RATTLESNAKE
The technology data
Operating voltage: 12V
Static currentLess than or equal to 8mA
Min trigger voltage for central locking & ACC:Is equal to or
greater than 9V
Max output current for one window: less than 12A
Operating temperature: +80Degrees Celsius-- -30Degrees Celsius
Installation:
1.Take the panel apart from the door beside driver, and then find
the socket of the power window controller which is same as our wire
plug as the diagram showing of the window closer and connect each
of them.(Shows as the above picture)
2.Brown wire:trigger signal wire, that’s for connecting the (+)
power cable of the lock in the original central locking.
3.The main socket output of the power window closer, for connecting
the socket of the power window closer.(Pay attention to the
direction)
4.After installation, please use the cable tie to fix the power
window closer tightly.( Please make sure the socket which with the
cables from the control box downwards).
5.Enclosed here the installation guide as the reference(The rear
side).
The working procedure:
After installation, the electronic window is on normal operation
when the car powered or started. And at the time when you descend
the window, power the car off, take out the key, and lock the door
or press the lock button on the remote control, AI window will
detect all the windows automatically, and close the windows from
the right-back, right-front, &left-back to left-front one by
one. And there is a buzzer alert of its mainframe after closing of
every window closing.
Installation notes:
Please find the professional technician to install this item, while
the technician is fixing the system, and find that the window is
not roll up automatically while lock the car door manually or by
the remote controller within 3s, then it should to check the
following points:
1-If the car is ACC ON;
2-Please make sure the socket of the system is connecting with the
car's original socket tightly;
3-If it is installed well by the signal trigger and control wire.
The installation procedure:
A.Take the panel apart from the door beside driver;
B.From the point 1 of the above picture(the power window panel),
Then find the socket of the power window controller which is same
as our wire plug as the diagram showing of the window closer and
connect each of them;
C.From the point 2 of the above picture,connect the brown wire of
window closer to the positive trigger wire of the central locking
in the door.
Notice:
1-After wire installation, please make sure they are connected well
and pack well with insulating tape;
2-Please make sure the socket which with the cables from the
control box downwards(Avoid the water coming inside);
3-Fix them tightly with the cable tie, which is avoid the driving
without the noise.
